SWIFT DZIRE CODE : AZI 3RD SERVICE 10000 KM

SWIFT DZIRE    CODE : AZI   3^RD SERVICE 10000 KM

ENGINE OIL                                                CHANGE

OIL FILTER                                                  CHANGE

GENERAL CHECK UP  i.e , CHECKING OF BATTERY WATER , ALL LIGHTS AND INDICATORS , BRAKE FLUID , REAR BREAK ( BRAKE SHOE , SPRING , BRAKE PISTON ETC. ) AND ALL ELECTRICAL SYSTEM LIKE HORN ETC.  

UNDER BODY CHECK UP LIKE CHECKING OF ALL NUT AND BOLT , LEAKAGE , CRACKS OR BREAKDOWN OF ANY COMPONENTS , SUSPENSION SPRINGS ETC.

4 WHEEL BALANCING AND ROTATION

WHEEL ALIGNMENT

PROCEDURE

ENGINE OIL AND OIL FILTER CHANGE

TO CHANGE ENGINE OIL FIRST OF ALL DRIVE THE CAR TO THE LIFT AND THEN SET THE CAR PROPERLY ON THE ARMS OF THE LIFTS AS THE SLOTS IS PROVIDED TO SET THE ARMS OF THE LIFT IN THE CAR .

 OPEN THE BONUT OF THE CAR AND PUT FANDER COVER ON THE BOTH SIDE OF THE CAR.

AND THEN LIFT THE CAR ON THE HYDRAULIC LIFT WITH THE BUTTON PROVIDED ON THE SIDE OF THE LIFT.

MAKE SURE THAT THE OIL IS NOT HOT OR IT MAY CAUSE INJURY

NOW TAKE THE TREY OR THE VESSEL IN WHICH DRAINED OIL IS STORED AND THEN SLOWLY OPEN THE DRAIN NUT WITH THE HELP PF SUITABLE SPANNER AND LET THE OIL TO DRAIN COMPLETELY AND THEN CLOSE THE DRAIN NUT

AFTER THAT TO CHANGE THE OIL FILTER OPEN IT WITH THE HELP OF FILTER WRENCH AND THEN TAKE NEW OIL FILTER AND THEN PUT A LITTLE BIT OF OIL ON THE GASKIT OF THE OIL FILTER AND THEN TIGHT THE OIL FILTER WITH THE HAND AND THEN FILTER WRENCH DON NOT OVER TIGHT THE FILTER GIVE PROER TORQE THAT IS NOT TOO TIGHT NOT TOO LOOSE

NOW OPEN THE LOCK OF THE LIFT AND DOWN THE LIFT WITH THE HELP OF LEVER PROVIDED ON THE SIDE OF THE LIFT

NOW OPEN THE CAP OF THE ENGINE AND THEN ADD SUITABLE ENGINE OIL 5W30 FOR PETROL CAR AND D5W30 FOR THE DIESEL CARS AND THE SWIFT CAR ENGINE OIL CAPACITY IS 3.1 LITRE